Kohler BEITOU K-72830T-L-CP Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Sanitarios Kohler BEITOU K-72830T-L-CP. Kohler BEITOU K-72830T-L-CP 2 páginas. Wall mount showerhead

Imprimir página
INSTALLATION
1
4
2
3
How to Install the Base
Determine the position of the base(1) will be mounted on the vertical wall according to the rough-in dimensions.
Make a suitable hole in the wall. Drill four holes(Ø10) as anchor(3) diameter and base position in the wall. The
center line of two vertical holes should be vertical.
Install the anchors, secure the base by the screws(2). NOTE: The out surface of the finished wall should be
between the MAX and MIN marks on the protector(4). Ensure the bottom of protector is horizontal by lever ruler.
Laminar
5
Waterfall
②
Rain
7
4
6
How to Install the Showerhead
When the finished wall is completed, take off the screws(6) and protector(4). The angle between connectors(7)
and finished wall should be 93 degrees.
1227406-2A-E
4
4
Level ruler
Level ruler
Use appropriate thread sealants or thread tape on the
water supplies(5). Connect water supplies to the base.
During installation, the protector remain on the base.
1
7
93º
93º
①
Remove the connectors(7) by hex wrench, take off
the filter washers(8). Flush water supplies for about
one minute to remove debris. Reinstall the
connectors and filter washers.
13
INSTALLATION CHECKOUT
Ensure that all connections are tight. Ensure that the handle is in the off position.
Turn on the drain and main water supply, and check for leaks. Repair as needed.
③
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
2
1227406-2A-E
8
7
④
Slide the escutcheon base(9) on the connector till it
against the wall, tighten it by screw(12) with
washer(11) and locking gasket(10).
14
Slide the showerhead kit(16) into the
15
escutcheon base.
10
11
Fix the showerhead by the screw(15)
with washer(11, 13) and locking
gasket(10). Press the cap(14).
16
⑥
9
11
10
12
⑤
3