Kohler K-1001-H2 Manual del propietario - Página 7

Navegue en línea o descargue pdf Manual del propietario para Sanitarios Kohler K-1001-H2. Kohler K-1001-H2 48 páginas. Tower custom hydro-massage system

Imprimir página

Using the Remote

The remote control places the user keypad functions at your ﬁngertips to further enhance your

hydro-massage experience. The functions of the remote are identical to the user keypad. You may

turn the system on and off, turn the heater on and off, and access/modify all hydro-massage

functions.

The mode selector button functions in the same way as the outer ring. When "M" is pressed, one of

the modes will ﬂash on the user keypad. If "M" is pressed again, the next mode in clockwise order

will ﬂash. When the desired mode is ﬂashing, press "OK" to activate it.

When the bodyjets or waterfall mode is active, the arrows will increase or decrease the water ﬂow

volume for the selected mode.

The waterproof remote control is designed to be used in the bath and will ﬂoat in the water.

Two AAA batteries are used in the remote control. To replace, simply unscrew the end cap and

insert the batteries, as shown above. Tighten the end cap securely, making sure the end cap makes

contact with the seal.

Programming the Remote

NOTE: Programming of the remote control is normally not required. If more than one device in your

home or in the near vicinity of your home uses a remote control, it may be necessary to program this

remote control to the user keypad. If you replace your remote control, or replace the pump control, it may

be necessary to program the remote control.

Turn the hydro-massage system power on.

Turn off all modes of operation. Wait approximately one minute until the keypad darkens

completely (sleep mode).

On the user keypad, press the up arrow, down arrow and the "OK" button simultaneously. The

bottom LED, on the keypad's indicator bar, will begin ﬂashing.

While the LED is ﬂashing, press the "OK" button on the keypad. A light sequence will illuminate

up and down the indicator bar.

While the indicator bar light sequence is active, press any button on the remote control. The

program will download and the user keypad will darken. The user keypad will now respond only

to this remote control.

FCC Compliance

FCC ID : N82-KOHLER001

Canada ID : 4554A-KOHLER001

Compliance Statement (Part 15.19)

Kohler Co.

Activates

Mode Selected

Mode

Selector

Power

Increases

Flow

Decreases

Flow

1030200-5-A