AEG LAVATHERM 57800 Información para el usuario - Página 21
Navegue en línea o descargue pdf Información para el usuario para Secadora AEG LAVATHERM 57800. AEG LAVATHERM 57800 32 páginas. Condensation dryer
Imprimir página
Problem
Drying cycle ends
shortly after pro-
gramme starts. END
display illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").
Changing bulb for interior light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the local Service Force Centre.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully remove the fuse.
1. Unscrew the lampcover (this can be found directly behind the loading
aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Replace the lampcover.
1
Warning! For reasons associated with safety, the lampcover must be
screwed down tightly. If this is not done, the dryer must not be operat-
ed.
Possible cause
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Heat exchanger clogged
with lint.
SPECIAL CARE button
pressed and load volume too
big.
Load volume too big.
Laundry insufficiently spun.
Remedy
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY instead of STORAGE
DRY).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE is only suitable
for use with loads of up to
3kg!
Reduce load volume.
Laundry must be adequately
spun.
21