AEG LAVATHERM 58840 Manual del usuario - Página 31

Navegue en línea o descargue pdf Manual del usuario para Secadora AEG LAVATHERM 58840. AEG LAVATHERM 58840 44 páginas. Condenser dryer

Imprimir página

Machine settings

BUZZER permanent on/off

Water hardness

Water contains, a variable quantity of

limestone and mineral salts of which

quantities vary according to geograph-

ical locations thus varying its conduc-

tivity values.

Relevant variations of the conductivity

of the water compared to those prefixed

by the factory could slightly influence

the residual humidity of the laundry at

the end of the cycle. Your dryer allows

you to regulate the sensitivity of the

drying sensor based on conductivity

values of the water.

Emptying water tank - warning mes-

sage permanent off

When using an external drain for the

condensed water.

Setting

Implementation

1. Turn the programme selector to any programme.

2. Press simultaneously the DRYNESS and SPIN SPEED

buttons and hold down for approx. 5 seconds.

3. The buzzer is by default always off. You can use the

BUZZER button to activate or deactivate sound but

the machine does not memorize your selection.

1. Turn the programme selector to any programme.

2. Press simultaneously the DRYNESS and TIME buttons

and hold down for approx. 5 seconds. The current

setting is on the display:

–

low conductivity <300 micro S/cm

–

medium conductivity 300-600 micro S/

–

high conductivity >600 micro S/cm

3. Press the START PAUSE button sequentially until you

set desired level.

4. To memorize setting press simultaneously the DRY-

NESS and TIME buttons or turn knob to OFF position

1. Turn the programme selector to any programme.

2. Press simultaneously the SPIN SPEED and TIME but-

tons and hold down for approx. 5 seconds.

The current setting is on the display:

– warning

icon and

is off

– warning

icon and

is switched on

By default the warning message is switched on and al-

ways displayed at the end of the drying cycle or during

the cycle if the water container is full.

Machine settings

- warning message