AEG LAVATHERM T56830 Información para el usuario - Página 22
Navegue en línea o descargue pdf Información para el usuario para Secadora AEG LAVATHERM T56830. AEG LAVATHERM T56830 33 páginas. Condensation dryer
También para AEG LAVATHERM T56830: Información para el usuario (33 páginas)
Imprimir página
Drying results
unsatisfactory.
Loading door does not
close.
When pressing a button,
the corresponding
button flashes several
times.
Drum light does not
work.
PROGRAMME TIME display
changes erratically or stays
unchanged for a long
time.
Programme inactive,
EMPTY WATER display
illuminated.
22
Problem
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged
with lint.
Overloading of laundry.
Ventilation slots in base
area covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation site differs from
standard setting of machi-
ne.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Programme selector in OFF
position.
Defective light bulb.
Programme time is correc-
ted automatically depen-
ding on type and volume of
laundry and level of dampn-
ess.
Condensate tank is full.
Possible cause
Remedy
Select a different program-
me the next time you dry
(see "Overview of program-
mes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended loa-
ding volumes.
Uncover ventilation slots in
base area.
Clean inside surface of
drum and drum ribs.
Re-programme standard set-
ting for degree of drying
(see 'Programming options'
section).
Install fine strainer and/or
snap large mesh filter into
place.
Turn the programme knob
to OFF Set the programme
again.
Turn programme selector to
LIGHT or to any programme.
Replace light bulb (see next
section).
Automatic process; this is
not a machine fault.
Empty condensate tank,
then start programme with
START/PAUSE button.