Kohler VINTAGE K-7158 Manual de instrucciones de instalación - Página 8
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Sanitarios Kohler VINTAGE K-7158. Kohler VINTAGE K-7158 9 páginas. Bath drains
También para Kohler VINTAGE K-7158: Manual de instalación (28 páginas), Manual de instalación (21 páginas)
Imprimir página
10. COMPLETE THE FINISHED WALL
Cover the framing with water resistant wall material, as
shown. Seal the joints between the bath rim edge and the
wall material with silicone sealant.
Tape and mud the water resistant wall material. Install
the finished wall to the water resistant wall material as
shown for your installation. Seal the joints between the
whirlpool rim and the finished wall material with
silicone sealant.
INSTALL THE FAUCET TRIM
11.
INSTALL HANDLES AND SPOUT
After the deck is finished, attach the handles and spout to
complete the faucet installation according to the faucet
manufacturer's instructions.
CLEAN UP AFTER INSTALLATION
12.
Remove stubborn stains, paint, or tar with turpentine or
paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with
any whirlpool surfaces for long periods of time.
Remove plaster by carefully scraping with a wood edge.
IMPORTANT CARE AND CLEANING INFORMATION
13.
Keep your cast iron product looking new by rinsing it
out thoroughly after each use. If the surface gets
excessively dirty, use a general purpose cleaner such
as: CloroxR Clean Up, 409R All Purpose, Mr. CleanR
Top Job, LysolR Foaming Disinfectant, Dow
Bathroom Cleaner, or FantastikR.
CALL US FOR HELP
Questions? Problems? First review the installation instructions to ensure correct installation. For additional
assistance, call our Customer Service Department for direct help. You may also contact us at our web site listed
below.
Kohler Co., Kohler, WI U.S.A.
Kohler Co., Kohler WI U.S.A.
Whirlpool
Do not use metal scrapers, wire brushes, or other
metal tools. Use a powder type detergent on a damp
cloth to provide mild abrasive action to any residual
plaster. When cleaning up after installation do not
use abrasive cleansers, as they may scratch and
dull the bath surface. Use warm water and a liquid
detergent to clean the surface.
Do not use abrasive cleansers or solvents on cast
iron products
In the U.S.A., call 1-800-4-KOHLER
In Mexico, call 001-877-680-1310
In Canada, call 1-800-964-5590
www.kohler.com
E2001 Kohler Co.
8
Apply Silicone
Sealant
Finished Wall
Material
Water Resistant Wall
Material
.
110050-2-
AB