Kohler K-1114-GLA Manual de puesta a punto - Página 2
Navegue en línea o descargue pdf Manual de puesta a punto para Bañeras Kohler K-1114-GLA. Kohler K-1114-GLA 4 páginas. Bath with airjets and integral apron
Imprimir página
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Recommended faucet area
1-1/4"
(3.2 cm)
Tile Flange
Detail
42" (106.7 cm)
Product Information
Applicable product:
Integral apron, left drain
Integral apron, right drain
Fixture*:
Bathing well
Basin area
55" (139.7 cm) x 23-1/4" (59.1 cm)
bottom
Basin area top
64" (162.6 cm) x 32" (81.3 cm)
Weight
149 lbs (68 kg)
To overflow
Water depth
15" (38.1 cm)
Capacity
78.5 gal (297 L)
* Approximate measurements for comparison only.
Blower motor:
Heater
1 hp
300 W
Minimum access panel pump/control:
20" (50.8 cm) W x 15" (38.1 cm) H
1076054-1-A
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1-1/4" (3.2 cm)
21"
(53.3 cm)
1-1/2" OD
K-1114-GLA
not shown
K-1114-GRA
shown
V
Hz
120
60
required
1" (2.5 cm) from
the Floor to the
Bottom of the Drain
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Blower motor is supplied with a 24" (61 cm) grounding-type
plug-in cord.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
39 lbs/square foot (190 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
The hot water supply should be 70% of the capacity of the bath or
greater. Installations will vary.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
A
are nominal.
5
2
11-1/16"
(28.1 cm)
72" (182.9 cm)
120 V, 5 A, 60 Hz
21"
(53.3 cm)
3-3/4"
(9.5 cm)
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Kohler Co.