Kohler REVIVAL K-873 Manual de instrucciones de instalación - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Bañeras Kohler REVIVAL K-873. Kohler REVIVAL K-873 8 páginas. 5' cast iron bath

Imprimir página

FINISHED FLOOR REQUIREMENTS - OPTIONAL K-8740 DRAIN SHROUD

NOTE: For installations that use the optional drain

shroud, the finished floor thickness cannot exceed

1-1/8". If the thickness of the finished floor exceeds

1-1/8", shim the bath to provide clearance for drain

shroud installation.

Apply a very thin (not to exceed 1/16"), even bead

of clear silicone sealant to the two back edges of the

drain shroud. Set the drain shroud aside on a clean,

soft surface until the silicone sealant has fully

cured.

NOTE: The purpose of this silicone sealant is to provide

a strain-relief cushion between the bath wall and the

drain shroud. It is not required to provide a water-tight

seal.

Center the drain shroud around the installed drain.

Be sure to align the holes in the shroud tabs with the

holes in the underside of the rim. Draw the outline of

the drain shroud bottom edge onto the subfloor

surface or a flat piece of cardboard. Then measure

and mark a series of closely-spaced cut lines

outward from the drain shroud outline. These cut

lines must be between 3/4" and 7/8" out from the

drain shroud outline.

NOTE: If the finished floor cut out is less than the 3/4"

minimum required, the finished floor will interfere with

future drain shroud removal and drain access. If the

finished floor cut out is more than the 7/8" maximum

required, the finished floor may extend beyond the

outside edges of the drain shroud base.

Use the cut lines to establish the finished floor

cut-out area for the drain shroud. Cut out the

finished floor.

Kohler Co., Kohler WI

Silicone

Sealant

Sub-floor

3/4"-7/8"

Drain Shroud

Cut line for

finished floor

114014-2-

Bath

(9537)