Kohler VOLUTE K-20610T-GR Instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Instrucciones de instalación para Bañeras Kohler VOLUTE K-20610T-GR. Kohler VOLUTE K-20610T-GR 5 páginas. Freestanding bath
También para Kohler VOLUTE K-20610T-GR: Instrucciones de instalación (5 páginas)

Imprimir página
Kohler VOLUTE K-20610T-GR Instrucciones de instalación

INSTALL THE PLUMBING

INSTALL THE PLUMBING
1.
Install the plumbing
!
Refer to the installation instructions of K-20608T/K-
20609T/K-99314T.
2. Open the hot and cold water supplies and check all
connections for leaks.
3. Run water into the bath and check the drain
connections for leaks.

COMPLETE THE INSTALLATION

COMPLETE THE INSTALLATION
Cast Iron Surfaces
When cleaning up after installation, do not use abrasive
cleaners, as they may scratch and dull the bath
surface. Use warm water and a liquid, non-abrasive
detergent to clean the surface.
CAUTION:
Do not allow cleaners containing
petroleum distillates to remain in contact with the
surfacer long periods of time.
Remove stubborn stains, paint, or tar with turpentine or
paint thinner.
Remove plaster by scraping with a wood edge. Do not
use metal scrapers, wire brushes, or other metal tools.
You can use a powder-type detergent on a damp cloth
to provide mild abrasive action to any residual plaster.

IMPORTANT CONSUMER INFORMATION

IMPORTANT CONSUMER INFORMATION
The Safeguard slip resistant surface on this bathtub
meets or exceeds the requirements of ASME/ANSI for
A112.19.1M slip resistance.
DANGER!!
Improper maintenance or cleansers may
permanently remove the slip resistant surface on
Kohler bathtubs.
NOTICE:
All housekeeping and maintenance
employees must be trained in the proper cleaning of
Kohler bathtubs. Post a copy of this notice in a readily-
visible location.
DO NOT
use steel wool, wire brushes, metal scrapers
or abrasive sponge pads to clean a Kohler bath tub.
DO NOT
use buffing machines on the slip resistant
surface.
DO NOT
use high alkaline or strong acid cleansers.
DO NOT
use abrasive cleansers.
!
Use only non-abrasive cleansers and a soft nylon
brush to clean the slip resistant surface.
!
When using commercial cleansers, use cleansers
with a pH of between three and eight.
!
Follow cleanser manufacturer instructions very
carefully.
1315528-T01-C
1.
!
K-20608T/K-20609T/K-99314T
2.
3.
Safeguard
A112.19.1M
!
!
pH 3 8
)
!
-5-
ASME/ANSI
(