Kohler ADAIR K-8699T Manual de instrucciones de instalación - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Aseos Kohler ADAIR K-8699T. Kohler ADAIR K-8699T 10 páginas.

Imprimir página

INSTALLATION

TO REMOVE EXISTING TOILET

Turn off the water supply. Flush the toilet, and use a sponge

to remove the remaining water from the tank and bowl.

Disconnect the supply shut-off valve (if present), and remove

the old tank and bowl.

Remove the old gasket from the floor

and the closet flange with a putty knife.

Remove the old T-bolts and discard

them.

NOTICE:

if the new toilet is not

installed immediately, temporarily stuff

a rag into the closet flange.

NOTICE: Do not use white cement or high lime content

cements to install this toilet. The expansion of cement due to

a rise in temperature may make the toilet crack or cause

damage. Kohler is not responsible for any damage caused by

installation with the use of cement.

TO INSTALL SUPPLY

SHUT-OFF VALVE

Install the supply shut-off valve so it is

200mm above the finished floor line,

and 160mm to the left of the closet

flange centerline.

The centerline of the supply shut-off

valve outlet should extend 67mm from

the finished wall. Install the supply

shut-off valve with the outlet vertical.

TO INSTALL BOWL

Position the template and align with

drain hole.

Mark down the position of foot and 5

holes.

Drill holes on ground with the drill of

10mm (3/8"), then insert anchor to

holes.

CAUTION: Please make sure there is

no water pipe or spool under the 5

holes to be drilled.

1285052-T01-A

Closet Flange

Supply Shut-Off Valve

160

200

Closet Flange

Centerline

305/400

Fig.#3

Drain Hole

Fig.#4

Fig.#5

-4-

(

)

Fig.#2

200mm

160

10mm

3/8

10mm

67mm;