Kohler K-11458 Manual del propietario - Página 4
Navegue en línea o descargue pdf Manual del propietario para Aseos Kohler K-11458. Kohler K-11458 32 páginas.
Imprimir página
Troubleshooting
This troubleshooting guide is for general aid only.
See the label on the inside of the toilet lid for service parts. Refer to the
illustration on the last page for parts identification.
Symptoms
Poor flush.
No flush.
Fill valve turns
on / off by itself
without toilet
being flushed,
or runs allow-
ing water to
enter tank.
Long tank fill
cycle.
Noisy tank fill
cycle.
Trip arm strikes
tank lid under-
side.
1042175-X5-B
• Adjust tank water level to match waterline.
• Fully open water supply shut-off valve.
• Clear obstruction in trapway, jet, or bowl rim holes.
• Clear obstruction in soil pipe or vent pipe.
• Reconnect flush ball chain to trip lever or flush valve.
• Adjust flush ball chain assembly to remove excessive slack.
• Adjust flush ball chain for proper slack so flush ball isn't held
off flush valve seat.
• Clean or replace flush ball if flush ball is worn, dirty, or
misaligned with flush valve seat or flush valve seat is
damaged Replace flush valve seal or flush valve.
• Remove tank and tighten flush valve nut if flush valve
gasket is leaking. Do not overtighten. If leakage continues,
replace gasket.
• Clean fill valve seat / seat washer of debris, or replace piston/
seat washer assembly.
• Replace fill valve if valve float sinks.
• Adjust tank water level if too high.
• Fully open water supply shut-off valve.
• Clean fill valve inlet, valve head, or supply line. Flush lines.
• Partially close water supply shut-off valve if water pressure
to toilet is too high. Check toilet performance following any
such adjustment.
• Remove dirt or obstruction in valve head. Flush lines.
• Adjust flush ball chain assembly to remove excessive slack.
• Adjust trip arm bracket and flange so they are parallel with
tank top.
Corrective action
4
Kohler Co.