Kohler Aegis LV680 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Motor Kohler Aegis LV680. Kohler Aegis LV680 21 páginas. Kohler liquid-cooled vertical crankshaft owner's manual

Imprimir página

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at

the customers expense, may be performed by any non-road engine repair establishment or individual.

Warranty repairs must be performed by an authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or

equipment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery

cable from battery.

Maintenance Schedule

These required maintenance procedures should be performed at the frequency stated in the table. They should

also be included as part of any seasonal tune-up.

Frequency

Daily or Before

Starting Engine

Every 25 Hours

Every 100 Hours

Annually or

Every 200 Hours

Annually or

Every 500 Hours

Every 2 Years or

Every 1000 Hours

Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.

Only required for Denso starters. Not necessary on Delco starters. Have a Kohler Engine Service Dealer perform

this service.

Check Oil Level

The importance of checking and maintaining the proper

oil level in the crankcase cannot be overemphasized.

Check oil BEFORE EACH USE as follows:

1. Make sure the engine is stopped, level, and is

cool so the oil has had time to drain into the sump.

2. To keep dirt, debris, etc., out of the engine, clean

the area around the dipstick before removing it.

3. Unthread and remove the dipstick; wipe oil off.

Reinsert the dipstick into the tube and rest the oil

fill cap on the tube. Do not thread the cap onto the

tube. See Figure 5.

Maintenance Instructions

Maintenance Required

• Fill fuel tank.

• Check oil level.

• Check coolant level.

• Check air cleaner for dirty

• Check air intake screen, radiator, and cooling areas, clean as necessary

• Service precleaner element

• Replace air cleaner element

• Clean and check cooling areas

• Change oil and oil filter (more frequently under severe conditions).

• Check spark plug condition and gap.

• Replace fuel filter.

• Have solenoid shift starter disassembled and cleaned

• Replace spark plugs.

• Change engine coolant.

, loose, or damaged parts.

Figure 5. Checking Oil Level.

4. Pull the dipstick out and check the oil level.

The oil level should be up to, but not over, the

"FULL" mark on the dipstick. See Figure 6.