Kohler Command 6 HP Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Motor Kohler Command 6 HP. Kohler Command 6 HP 17 páginas. Horizontal crankshaft
También para Kohler Command 6 HP: Manual del usuario (16 páginas), Manual del usuario (16 páginas), Manual del usuario (16 páginas)
Imprimir página
Fuel Recommendations
WARNING: Explosive Fuel!
Gasoline is extremely flammable and its vapors can
explode if ignited. Store gasoline only in approved
containers, in well ventilated, unoccupied buildings,
away from sparks or flames. Do not fill the fuel tank
while the engine is hot or running, since spilled fuel
could ignite if it comes in contact with hot parts or
sparks from ignition. Do not start the engine near
spilled fuel. Never use gasoline as a cleaning agent.
General Recommendations
Purchase gasoline in small quantities and store in clean,
approved containers. A container with a capacity of 2
gallons or less with a pouring spout is recommended.
Such a container is easier to handle and helps eliminate
spillage during refueling.
Do not use gasoline left over from the previous season,
to minimize gum deposits in your fuel system and to
insure easy starting.
Do not add oil to the gasoline.
Do not overfill the fuel tank. Leave room for the fuel to
expand.
Fuel Type
For best results use only clean, fresh, unleaded
gasoline with a pump sticker octane rating of 87 or
higher. In countries using the Research method, it
should be 90 octane minimum.
Unleaded gasoline is recommended as it leaves less
combustion chamber deposits. Leaded gasoline may be
used in areas where unleaded is not available and
exhaust emissions are not regulated. Be aware however,
that the cylinder head will require more frequent service.
Gasoline/Alcohol blends
Gasohol (up to 10% ethyl alcohol, 90% unleaded
gasoline by volume) is approved as a fuel for Kohler
engines. Other gasoline/alcohol blends are not
approved.
Gasoline/Ether blends
Methyl Tertiary Butyl Ether (MTBE) and unleaded
gasoline blends (up to a maximum of 15% MTBE by
volume) are approved as a fuel for Kohler engines.
Other gasoline/ether blends are not approved.
Engine Identification Numbers
When ordering parts, or in any communication involving
an engine, always give the Model, Specification, and
Serial Numbers of the engine.
The engine identification numbers appear on decal (or
decals) affixed to the engine shrouding. Include letter
suffixes, if there are any.
Record your engine identification numbers on the
identification label below (Figure 4) for future reference.
MODEL NO.
SPEC. NO.
DISPL (CC)
SERIAL NO.
REFER TO OWNER'S MANUAL FOR
SAFETY, MAINTENANCE SPECS
AND ADJUSTMENTS. FOR SALES
AND SERVICE IN US/CANADA CALL:
1-800-544-2444
KOHLER CO. KOHLER, WI USA
IMPORTANT ENGINE INFORMATION
THIS ENGINE CONFORMS TO U.S.
EPA PHASE 1 & 1995-1998
CALIFORNIA EMISSION CONTROL
REGULATIONS FOR ULGE ENGINES
FAMILY
MODEL NO.
SPEC. NO.
DISPL (CC)
SERIAL NO.
REFER TO OWNER'S MANUAL FOR
SAFETY, MAINTENANCE SPECS, AND
ADJUSTMENTS. FOR SALES AND
SERVICE IN US/CANADA CALL:
1-800-544-2444
KOHLER CO. KOHLER, WI USA
If your engine has this identification label, it is
certified to meet EPA/CARB standards.
Figure 4. Engine Identification Labels.
5