Kohler Courage SV620 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Motor Kohler Courage SV620. Kohler Courage SV620 17 páginas. Vertical crankshaft
También para Kohler Courage SV620: Manual del usuario (17 páginas), Manual del usuario (8 páginas), Manual del usuario (48 páginas)

Imprimir página

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the

customers expense, may be performed by any non-road engine repair establishment or individual. Warranty

repairs must be performed by an authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment, disable

the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable from battery.

Maintenance Schedule

These required maintenance procedures should be performed at the frequency stated in the table. They should

also be included as part of any seasonal tune-up.

Frequency

Daily or Before

Starting Engine

Every 2 Months

or 25 Hours

Annually or

Every 100 Hours

Every 2 Years or

200 Hours

Every 200 Hours

Every 200 to 400 Hours

Every 500 Hours

¹Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.

²Have a Kohler Engine Service Dealer perform this service.

Check Oil Level

The importance of checking and maintaining the

proper oil level in the crankcase cannot be

overemphasized. Check oil BEFORE EACH USE as

follows:

1. Make sure the engine is stopped, level, and is cool

so the oil has had time to drain into the sump.

2. To keep dirt, grass clippings, etc., out of the

engine, clean the area around the oil fill cap/

dipstick before removing it.

3. Pull and remove the oil fill cap/dipstick; wipe oil

off. Reinsert the dipstick and push firmly into

place. See Figure 6.

Maintenance Instructions

Maintenance Required

• Fill fuel tank.

• Check oil level.

• Check air cleaner for dirty¹, loose, or damaged parts.

• Check air intake and cooling areas, clean as necessary¹.

• Service precleaner element¹ (if equipped).

• Service air cleaner element¹ (if not equipped with precleaner).

• Replace air cleaner element¹ (if equipped with precleaner).

• Change oil and filter (refer to Viscosity Table, Page 4, based on seasonal

temperatures).

• Remove blower housing and clean cooling areas.

• Check that all fasteners are in place and components are properly secured.

• Replace fuel filter.

• Check spark plug condition and gap.

• Have bendix starter drive serviced².

• Have valve lash checked/adjusted².

• Clean combustion chamber².

• Replace spark plug.

Removing

Dipstick

Figure 6. Checking Oil Level.

4. Remove the dipstick and check the oil level.

The oil level should be up to, but not over, the "F"

mark on the dipstick. See Figure 7.

Dipstick Seated