Kohler Magnum 8 HP Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Motor Kohler Magnum 8 HP. Kohler Magnum 8 HP 17 páginas. Horizontal crankshaft
También para Kohler Magnum 8 HP: Manual del usuario (17 páginas), Manual del usuario (16 páginas), Manual del usuario (16 páginas)

Imprimir página

Troubleshooting

When troubles occur, be sure to check the simple causes which, at first, may seem to obvious to be considered.

For example, a starting problem could be caused by an empty fuel tank. Some common causes of engine troubles

are listed in the following table.

Do not attempt to service or replace major engine components, or any items that require special timing or

adjustment procedures. Have your Kohler Engine Service Dealer do this work.

Possible Cause No

Improper

Dirt In

Dirty

Incorrect

Engine

Dirty Air

Faulty

Problem

Fuel

Fuel Line Grass Screen

Oil Level

Overloaded

Cleaner

Spark Plug

Will Not Start

Hard Starting

Stops Suddenly

Lacks Power

Operates Erratically

Knocks or Pings

Skips or Misfires

Backfires

Overheats

Hiah Fuel Consumntion

Storage

If the engine will be out of service for two months or

more, use the following storage procedure:

Clean the exterior surfaces of the engine.

2. Change the oil and filter while the engine is still

warm from operation. See "Change Oil" on

page 8.

3. Change oil in reduction gear unit, if so equipped.

Refill with the same oil as used in engine

crankcase for season of operation. See page 10.

The fuel system must be completely emptied, or

the gasoline must be treated with a stabilizer to

prevent deterioration. If you choose to use a

stabilizer, follow the manufacturers

recommendations, and add the correct amount for

the capacity of the fuel system. Fill the fuel tank

with clean, fresh gasoline. Run the engine for 2-3

minutes to get stabilized fuel into the carburetor.

To empty the system, run the engine until the fuel

tank and system are empty.

Remove the spark plug. Add one tablespoon of

engine oil into the spark plug hole. Install the plug,

but do not connect the plug lead. Crank the engine

two or three revolutions.

6. Remove the spark plug. Cover the spark plug hole

with your thumb, and turn the engine over until the

piston is at the top of its stroke. (Pressure against

thumb is greatest.) Reinstall the plug, but do not

connect the plug lead.

Store the engine in a clean, dry place.

Parts Ordering

The engine Specification, Model, and Serial Numbers

are required when ordering replacement parts from

your Kohler Engine Service Dealer. These numbers are

found on the identification plate which is affixed to the

engine shrouding. Include letter suffixes if there are

any. See "Engine Identification Numbers" on page 5.

Always insist on genuine Kohler parts. All genuine

Kohler parts meet strict standards for fit, reliability, and

performance.