Kohler 15REYG Operación - Página 29

Navegue en línea o descargue pdf Operación para Generador portátil Kohler 15REYG. Kohler 15REYG 40 páginas. Commercial generator sets

Imprimir página

Battery short circuits. Explosion can cause severe injury

or death.

Short circuits can cause bodily injury and/or

equipment damage. Disconnect the battery before generator

set installation or maintenance. Remove all jewelry before

servicing the equipment. Use tools with insulated handles.

Remove the negative (--) lead first when disconnecting the

battery.

Reconnect the negative (--) lead last when

reconnecting the battery. Never connect the negative (--)

battery cable to the positive (+) connection terminal of the

starter solenoid. Do not test the battery condition by shorting

the terminals together.

3.9 Belt Check

Check the belt tension at the intervals specified in the

service schedule. If the tension is not within

specification, adjust as necessary using the following

procedure.

Adjust the tension of the alternator/fan belt so that the

belt can be depressed about 7--10 mm (0.3--0.4 in.)

when applying finger pressure.

procedure to adjust the belt.

1. Battery charging alternator pulley

2. Adjusting screw

3. Check the alternator belt tension here

4. Alternator pivot screw

Figure 3-11 Belt Tension

Belt Tensioning Procedure

1. Disconnect the battery, negative lead first.

2. Loosen the pivot and adjusting screws.

3. While prying the battery charging alternator

outward, tighten the adjusting screw.

TP-6728 10/11

Use the following

4. Tighten the pivot screw.

5. Recheck and adjust as necessary.

6. Reconnect the battery, negative lead last.

Note: Also check the fan belt for cracks or tears

and replace the belt if necessary.

3.10 Storage Procedure

Follow the procedure below when storing your

generator set for a long period (3 months or more).

1. Start and run the generator set until it reaches

operating temperature or about 15 minutes.

2. Stop the generator set.

3. Change the oil and oil filter; see Section 3.3.5, Oil

and Filter Change.

4. Drain the fuel completely from the fuel tank to

prevent accumulated moisture from mixing with the

fuel.

5. Check the engine coolant protection; see

Section 3.6.

Note: Use antifreeze capable of withstanding the

lowest possible temperatures.

6. Keep spark plugs in their holes or seal spark plug

holes with suitable threaded metal plugs.

7. Clean the exterior of the generator set and spread a

light film of oil or silicon spray over any exposed

surfaces that may be subject to rust or corrosion.

8. Seal the air inlet, exhaust pipe, and fuel tank cap

with tape.

9. Disconnect and remove the battery. Place the

battery in a warm, dry location for the storage

period. Recharge the battery once a month to

maintain a full charge.

10. Select a well-ventilated (not humid or dusty)

location to store the generator.

11. Cover the entire unit with a dust cover.

Note: Run the generator set once a month

whenever possible.

Section 3 Scheduled Maintenance