Kohler 275547 Instrucciones - Página 2

Navegue en línea o descargue pdf Instrucciones para Generador portátil Kohler 275547. Kohler 275547 4 páginas. Throttle repair kits for generator sets

Imprimir página

c. Assemble rod and ball joint linkage as shown

in installation drawing. Attach linkage to

governor throttle lever with hardware

indicated in Figure 1 or Figure 2. Do not

connect linkage to mounting bracket until

next step.

d. To correctly set throttle rod length, rotate

throttle lever clockwise until lever stops

against the fast idle adjusting screw. Rotate

throttle lever an additional 10 degrees

clockwise then attach ball joint on free end

of rod to mounting bracket. When properly

adjusted, the spring on the throttle lever will

be slightly extended. See Figure 3.

3.2 125---180ROZJ Models

a. Remove hardware securing throttle lever to

governor shaft. Remove and discard throttle

lever and mounting screws.

Kit No. 275547 20---40ROZJ

Figure 1. Throttle Repair Kits for 20---60ROZJ

b. Attach throttle bracket (275546) to governor

shaft with screws and washers as shown in

Figures 4 and 5. Torque to 28 ft. lbs. (40 Nm).

When installed, the throttle bracket should

contact the governor stop screw to hold the

throttle in the full---open position against the

idle speed adjusting screw.

CHANGE POSITION OF IDLE SPEED

ADJUSTING SCREW.

4. Reconnect

generator

negative lead last.

5. Start generator set. Using a tachometer or

frequency meter on controller (if equipped),

check engine full load speed. Engine speed

should be 1800 rpm at 60 Hz and 1500 at 50

Hz operation. If engine speed is incorrect,

refer to the generator service manual for

governor adjustment procedure.

Kit No. 275548 50---60ROZJ

DO NOT

starting

battery,