Kohler K-2488 Manual de instalación y mantenimiento - Página 3

Navegue en línea o descargue pdf Manual de instalación y mantenimiento para Mobiliario interior Kohler K-2488. Kohler K-2488 24 páginas.

Tools/Outils/Herramientas

Siliconized Acrylic Caulk

Mastic à l'acrylique siliconée

2x6 Lumber or 3/4" Plywood Panel

Sellador acrílico siliconado

Planche de 2x6 ou panneau en contreplaqué de 3/4"

Postes de madera de 2x6 o panel de madera contrachapada de 3/4"

Before You Begin

CAUTION: Risk of property damage. Select the type of fastener based on the

wall material. Fasteners must have a minimum of 20 lb (9.07 kg) load bearing.

Install fasteners (not provided) through the vanity and into a header to avoid

possible property and product damage. If this is not possible, wall anchors (not

provided) must be inserted before installing the fasteners.

NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.

Do not use 100% silicone sealant, which will damage the ﬁnish of the vanity.

NOTICE: In order for the installation to be successful, the vanity must be level and

plumb. If necessary, rotate the levelers underneath the vanity feet.

NOTICE: This installation is easiest with two people.

Observe all local plumbing and building codes.

The appearance of your vanity may differ from the illustrations in this guide. The

instructions still apply.

Prior to installation, unpack the new product and inspect it for damage. Return

the product to its protective carton until you are ready to install it.

Select fasteners that are long enough to secure the vanity to the header. Take into

account the combined thickness of the back of the vanity and wall material.

Make sure the ﬁnished wall is straight and plumb, and the ﬂoor is ﬂat and

perpendicular to the ﬁnished wall.

Remove any moldings that may inhibit the vanity from being ﬂush against the

ﬁnished wall.

Kohler Co. reserves the right to make revisions in the design of products without

notice, as speciﬁed in the Price Book.

ATTENTION: Risque d'endommagement du matériel. Sélectionner le type de

ﬁxation selon le matériau du mur. Les ﬁxations doivent avoir une capacité de

support minimum de 20 lb (9,07 kg). Installer les ﬁxations (non-fournies) dans le

meuble et un linteau aﬁn déviter un endommagement éventuel de propriété et de

produit. Si ceci n'est pas possible, les ancrages muraux (non-fournis) doivent être

insérés avant d'installer les ﬁxations.

Kohler Co.

Plus/Plus/Más:

• Wood Screws/Vis à bois/Tornillos para madera

• Framing Nails

Clous de cadrage

Clavos para estructuras de madera

1068637-2-C