A-TOUCH W-Thermo Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Termostato A-TOUCH W-Thermo. A-TOUCH W-Thermo 15 páginas.

Imprimir página

The SCENARIO will select directly the mode as defined for the scenario,

regardless of its starting mode.

You cannot change the temperature or the ventilation speed with a remote

key.

Associating a key to the thermostat

The programming follows exactly the same rules as programming keys and outputs

on the automation system. Please refer for the Home Automation User Manual for

more details.

To control the thermostat with an automation key proceed as follows:

If the key you used is configured to send the command SCENARIO, you must now

store the unit's operation mode for the scenario:

USING THE THERMOSTAT KEYS TO CONTROL AUTOMATION OUTPUTS

If the thermostat is programmed to operate according to the schedule you defined

then you will need very little or even no interaction with it, as it always operates

automatically.

In this case you can decide to use the keys of the thermostat to do something else,

for example switch lights on and off or control shutters or curtains.

The thermostat panel can operate in Thermostat mode (default operation) but also

in Automation mode, where all the keys are normal automation keys (no operation

of the thermostat if they are not programmed to do it).

In Automation mode, the panel has all the keys available:

4 direct keys

2 horizontal sliding keys

2 vertical sliding keys

1 multi-touch key (all 4 keys together)

In Thermostat mode, the panel has the 4 direct keys for the operation of the

thermostat, but the sliding and multi-touch keys are still available:

2 horizontal sliding keys

2 vertical sliding keys

1 multi-touch key (all 4 keys together)

To switch between Thermostat mode and Automation mode proceed as follows:

22º

21.2º

22º

21.2

[email protected]

Press the key

(PROG) on the thermostat:

- you will hear one BEEP on the panel.

Now press the key on the automation panel:

- you will hear a long BEEP: from this moment on, the thermostat

will react to that key.

Put the thermostat in the mode you want it to be in the scenario.

Now hold the SCENARIO key for more than 5 seconds:

- you will hear a long BEEP on the panel: the scenario is stored.

Hold the keys

(UP) and

seconds on the thermostat panel:

- you will hear 2 short BEEPs on the panel: the display layout

changes to Automation mode.

Now you can use the keys of the thermostat for automation.

(VENT) pressed together for more than 5