Aqua 72252 Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de filtración de agua Aqua 72252. Aqua 72252 8 páginas. Sand filter system
SAFETY INFORMATION
1
The sand filters are designed to work with water at temperature>than 0! and <than 45!.The
filter should never be operated outside of these temperatures or damage may occur.
2
The installation should be carried out in accordance to the safety instructions of swimming
pools and the specific instructions for each facility
3
The user should make sure that the installation is carried out by qualified authorized persons and
that these persons have first carefully read the following instructions. Incorrectly installed
equipment may fail, causing severe injury or property damage
4
The operating safety of the filter is only guaranteed if the installation and operation instructions
are correctly followed.
5
To reduce the risk of injury, do not permit children to use this product.
6
Chemical spills and fumes can weaken Swimming Pool/ Spa. Corrosion can cause filters and other
equipment to fail, resulting in severe injury or property damage. Do not store pool chemicals near your
equipment.
7
Any modification of the filter requires the prior consent from the supplier s original replacement parts
and accessories authorized by the manufacturer ensure a high level of safety. The supplier assumes
no liability for the damage and injuries caused by unauthorized replacement parts and accessories.
8
In the event of defective operation or fault, contact the supplier or its nearest authorized service agent
Sand Filtration working principle
Incoming water from the piping system is automatically directed by the Multiport Valve to the
top of the filter bed. As the water is pumped through the filter sand, dirt and debris are
trapped by the filter bed, and filtered out. The filtered water is returned from the bottom of
the filter tank, through the Multiport Valve and back through the piping system
Preparation before installation
1
Position the filter as close to the Swimming Pool/ Spa as possible.
2
The filter should be placed on a level concrete slab, very firm ground, or equivalent. Ensure that the
ground will not subside, preventing any strain from the attached plumbing.
3
Position the filter under consideration of the piping connections, so that it is convenient for
operating and servicing.
4
Ensure that the compliance label is facing the front to allow easy identification in the case of service
difficulties.
How to install the filter tank
1
Put the filter tank on the base, turn right to tight up. Position the outlet drain plug is facing
outside for easy operation.
2
Before filling the filter media into the filter vessel, do a visual check of the laterals. Replace the
broken or loose laterals if necessary. (The laterals of side-mount valve sand filter are all
installed). And then install the laterals, match the Raised Point of laterals to Folding Umbrella
lateral holder, insert the laterals and turn 90 clockwise, after hearing the sound, the lateral is
well installed. Please refer to the following picture.