Avlite AV-FL-DC Manual de instalación y mantenimiento - Página 6
Navegue en línea o descargue pdf Manual de instalación y mantenimiento para Luz de inundación Avlite AV-FL-DC. Avlite AV-FL-DC 12 páginas. Universal dc helipad floodlight
The installation of the AV-FL-RF-SOL Solar Aviation Light includes the following steps:-
•
Unpacking
•
Initial Inspection
•
Assembling the light & configuration of settings
•
Installing the light assembly
Tools required for assembly & installation:-
•
Hammer
•
6mm Allen Key
Unpacking & Initial Inspection
Unpack all hardware and inspect for damage. If there is any damage, please contact your Avlite Office.
Retain original packing material for possible future use in shipping the AV-FL-DC.
Assembling the Light & Configuration of Settings
1. Before activating the lights, the lights must be layed out on the helipad in the
location they will be installed.
2. Lights should always be installed on mounting plates or stakes.
a) LED Floodlight Unit
•
Setup a number
of concrete pads at equidistant points around the TLOF at ground level. The
1
concrete pads should have a dimension of approximately 40cm x 40cm with with sufficient depth
depending on soil conditions. NOTE: As an alternative it is possible to use rubber tiles instead of
concrete pads.
•
Embed four bolts. Use the Mount Base as a placing template
•
Make sure the concrete pads are dry and hard before fixing the Mount Base using washers and
screw nuts. Make sure the Mount Base is levelled
•
Fix the Frangible Sleeve (76mm) on top of the Mount Base using the hex socket
•
Fix the LED Floodlight Unit on top of the Frangible Sleeve
•
Point the LED Floodlight Unit into the desired direction
below 25cm high and levelled
•
Fix the light by tightening the hex sockets at the Frangible Sleeve
•
Connect the LED Floodlight Unit to a DC power supply
Number of required / planned lights
1
Please refer to "TLOF Light Arrangement" section of this manual
2
Latest products and information available at www.avlite.com
Assembly & Installation
6
Universal DC Helipad Floodlight
. Make sure the LED Floodlight Unit is just
2
AV-FL-DC