Aqua Creek Products F-MTY4PDS Manual - Página 5

Navegue en línea o descargue pdf Manual para Sistemas de elevación Aqua Creek Products F-MTY4PDS. Aqua Creek Products F-MTY4PDS 6 páginas. Mighty lifts shallow deck pedestal

Imprimir página

Anchor Installation

Remove 1 nut from each anchor insert. Place the anchor inserts through the larger hole of the anchor jig plate.

Thread the removed nuts back onto the anchor inserts. The anchor plate should be sandwiched between the two nuts

on each anchor insert. SEE SECTION D-D

Install rebar in the open area of the deck. SEE FIGURE 03 & SECTION D-D

Set the anchor system in place. Make sure the center of the large anchor jig plate holes aren't set back further

than the max distance provided on page 3.

Make sure the top of each anchor body is flush with the

adjusted individually by turning the nuts with a large wrench.

Bond the anchoring system by using the bonding lug on the anchor plate. Bond the system according to your

local code requirements. SEE FIGURE 03 (See NEC Article 680.26)

Pour your concrete and finish the pool deck surface. SEE FIGURE 03

Once the concrete has cured your lift is ready to be mounted to the anchoring system. SEE FIGURE 04 & 05

FIGURE 04

New Construction

BOLT - HEX 1/2"-13x1 1/2"

WASHER - FLAT 1/2"

BOLT - HEX 1/2"-13x1 1/2"

WASHER - FLAT 1/2"

FINISHED

deck surface. Each anchor body can be

FIGURE 05

WASHER - ET 1/2"

WASHER - FLAT 1/2"

NUT - NNL 1/2"-13

5 OF 6

10/26/2020 12:35:29 PM