AVM EVOLUTION CD2 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Reproductor de CD AVM EVOLUTION CD2. AVM EVOLUTION CD2 19 páginas. Cd-player evolution

END OF REPLAY AND CANCEllATION OF PROGRAMMING

Pressing the button STOP (12) ends the replay process and cancels any previously programmed functions

such as REP I. RPAL. TIME. PAUSE etc. OPEN (9) will have the same effect and additionally open the tray.

Ifthe button STOP (12) is pressed once while the unit is in the mode PPLAY (Program PLAY) the CD2

will stop playback and permit programming of additional titles to those already selected. By pressing the butt-

ton STOP (12) twice in short succession programming is cancelled and the CD2 will stop (STOP will be

displayed).

SWITCHING THE DISPLAY ON OR OFF

If the illumination of the display is disturbing it can be switched off by pressing DISPLAY OFF (13) at any

time during playback. Renewed pressing of the button reactivates the display. The display will light up for a

short period when one of the functions (e.g. title skipping etc) is being operated. even in the condition

DISPLAY OFF. The display is constantly illuminated ifthe CD2 is in STOP

PAUSE mode despite the

button DISPLAY OFF having been activated.

REMOTE CONTROL I PROGRAMMING (OPTIONAL AVAILABLE)

The system remote control enables programming. direct title selection and further functions of the CD2 in

addition to the basic functions.

GENERAL DETAILS OF THE REMOTE CONTROL

The desired functions can be obtained through pressing the relevant buttons on the remote control trans-

mitter. Always direct the remote control at the display window (7) of the CD2. This is the location of the

infra-red receiver.

SWITCHING ON

Operation of the button ON (22) will switch the CD2 unit on.The equipment is immediately ready for use.

The "WARM UP" phase described in the section "Switching on the power supply" is reduced to about 2 sec-

onds.

SWITCHING OFF

The CD2 unit will go to stand by mode after activation of the button OFF (21). The display extinguishes.

The control LED (I) remains illuminated.The mains supply power requirement ofthe CD2 is reduced to less

than I Watt.