Aqua Link UV-C TECH 130W Manual - Página 6

Navegue en línea o descargue pdf Manual para Productos de fontanería Aqua Link UV-C TECH 130W. Aqua Link UV-C TECH 130W 8 páginas.

UV-C TECH

OPERATION

In the UV-C Tech, a UV-C radiation with a wavelength of 253.7 nm is generated by the special UV-C

lamp, ensuring a lethal effect on bacteria, viruses and moulds (including Legionella bacteria and

Cryptosporidium). The UV-C Tech will ensure that your pool water is clean, fresh and clear in an

efficient and environmentally-friendly manner. The water is led through the UV-C device via a pump.

The UV-C radiation neutralises bacteria, viruses and other microorganisms and stops them from

multiplying. The UV-C Tech has a built-in electronic ballast. This ballast ensures optimum

performance of the lamp. In addition, the stainless steel interior of the reactor ensures the reflection

of the UV-C rays, thereby increasing the efficiency up to 35%. Thanks to the UV-C Tech, your

swimming pool water will be disinfected efficiently and safely, and the quality of your water will

remain excellent.

* The UV-C Tech 130 watt amalgam lamp is not affected by temperature fluctuations in the water

and generates a constant, powerful radiation.

INSTALLATION OF THE EARTH (DRAWING 1)

1. Pull the cable (2) through the strain relief (4) before fitting the synthetic strain relief (4) onto the earth

bolt (1). Position the strain relief (4) at approximately 10 cm from the eye (2) of the earth cable.

2. Place the eye (2) of the cable onto the earth bolt that is fitted to the housing.

3. Then place a toothed lock washer (3).

4. Fit the strain relief (4), creating a loop of Ø5 cm.

5. Finally place the second toothed lock washer (5) and the lock nut (6) onto the earth bolt.

6. Once the parts have been placed onto the earth bolt in the correct sequence, they can be

tightened with a spanner or a ring spanner number 8.

INSTALLATION OF THE UV-C DEVICE (DRAWING 2)

Determine where the device will be installed. The UV-C Tech must never be installed behind the Ph

regulator or the salt electrolysis system in your swimming pool installation. The ideal location to

install your device is immediately behind the filter. The installation must always take place outside of

the pool. Ensure that there is always water flowing through the unit when the lamp is on. Never

install the unit in an area exposed to full sunlight. The installation must always take place in a dry

and well-ventilated area. The device must be fitted in the vertical position, and a space of 30 cm

must be available underneath to carry out maintenance. An area of approx. 1.5 m must be available

at the top in order to be able to replace the lamp (K) smoothly without having to dismantle the

complete device.

1. Unscrew the screw ring (N) from the housing (U). Remove the UV-C lamp (K) from the supplied

case (see packaging) and carefully slide the lamp into the quartz glass (M). Carefully connect the

white lamp holder (L) to the UV-C lamp (K) and then screw the screw ring (N) hand-tight onto

the housing (U).

| UV-C TECH

Please read through these instructions for use

carefully before installing this device.