DeZurik G-SERIES Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Controlador DeZurik G-SERIES. DeZurik G-SERIES 13 páginas. Lift, turn and reseat used on ptw & pfw tapered plug valves
También para DeZurik G-SERIES: Instrucción (7 páginas), Manual (8 páginas), Manual (17 páginas), Manual (14 páginas), Manual (12 páginas), Manual (14 páginas), Manual (16 páginas), Instrucción (19 páginas), Manual (17 páginas), Manual (9 páginas)

Imprimir página

DeZurik G-SERIES Manual de instrucciones

G-Series Cylinder Actuator Used on BAW Butterfly Valves

Reassembling Actuator

7. Place a new gasket (B26) on the cylinder head.

8. Install the cylinder/rack rod assembly by sliding the rack rod through the rack (B4) and fasten

the cylinder to the housing (B1) with screws (B27).

NOTE: If the rack rod is not attached to the cylinder assembly, clean the threads of both the rack rod and

the cylinder shaft, then apply Loctite to the cylinder shaft threads and screw the rack rod onto the cylinder

shaft.

9. Slide the spacer (B21) onto the rack rod (B6) and screw the jam nut (B22) onto the rack rod

(B6) until the spacer is tight against the rack (B4).

10. Screw the cap nut (B25) onto the rack rod (B6) and tighten the two nuts against each other.

August 2012

(Continued)

Figure 7 – Gear and Rack Alignment

Page 11

DeZURIK

D10480