Aqua Lung PARA SWIMMER VEST Manual del usuario

Navegue en línea o descargue pdf Manual del usuario para Equipos de seguridad Aqua Lung PARA SWIMMER VEST. Aqua Lung PARA SWIMMER VEST 2 páginas.

Imprimir página

5. Inflate the vest with air, turn it to an inverted position and drain any water out

through the over pressure relief valve (OPRV) by pulling down on the knob

and cord assembly. If water drains from inside the vest, a fresh water rinse

should be done as follows.

a. To fresh water rinse the vest unscrew the OPRV, directly fill the vest

with water and re-thread the OPRV to the vest.

b. Swish the water around to remove any mineral deposits, invert the vest

so the OPRV is the lowest point and drain the water by pulling the knob

and cord assembly. Taste the last remaining drops of water for salt. If

salt is detected, repeat the cleaning procedure for the internal bladder.

6. To dry the vest after cleaning, inflate the vest until it is half full, this will allow

the inner bladder to dry. DO NOT dry the vest in direct sunlight. Store the

half full, inflated vest in a cool, dry and clean area.

7. Check the vest 30 minutes later for any leakage. If any leakage or holes are

detected, repair the vest utilizing the Aqua Lung Repair Kit pn 42611.

WARNING:

DO NOT use aerosol silicone sprays or cleaners to

lubricate the components, the propellants or carrier solvent

cause cracking or crazing.

WARRANTY

Aqua Lung America Inc. warrants this product to be free from defects in material and

workmanship for a period of one year from the date of original purchase. Aqua Lung

will repair or replace products that prove to be defective under normal conditions

and proper use.

2340 Cousteau Court, Vista, CA 92081

Phone (760) 597-5000 Fax (760) 597-4914

www.aqualung.com/militaryandprofessional

Literature PN 18295

•

DONNING AND ADJUSTMENT PROCEDURES

Place the Para Swimmer Vest over your head. Route both straps underneath

your arms, through the D-rings and then tighten straps. (See Fig. 1).

Fully inflate the Para Swimmer Vest by loosening the knurl nut on the oral

inflation tube and depress the oral inflator valve. Exhale into the valve

until the vest is full (See Fig. 2). If the fit is too tight, adjust the straps for

comfort.

Rev 6/12

PARA SWIMMER VEST

Part no. 769041

Before using the Para Swimmer Vest you must read the

instruction sheet completely.

Before using, inspect the entire vest for leakage or other

damage. If any part of the vest does not function properly, or

it is damaged, remove the Para Swimmer Vest from service

until repaired.

Do not inhale from the Para Swimmer Vest oral inflator. The

vest may contain contaminants from a previous CO

or other source.

The Para Swimmer Vest is not approved for use in SCUBA Diving.

Figure 1

firing

Figure 2