Avocet 45tt Manual - Página 5

Navegue en línea o descargue pdf Manual para Ciclómetro Avocet 45tt. Avocet 45tt 13 páginas.

Imprimir página

TRIP DISTANCE (D).

with 0.01 resolution and from 200.0 to 1999.9 with 0.1 resolution. The

display freezes when it reaches 1,999.9 miles. Reset individually by pressing

both buttons when trip distance is displayed.

Most riders measure trip distance for an entire ride and zero the display

with a global reset before they start riding. The high resolution of the Cy-

clometer 45tt's Trip Distance display, and the Cyclometer's excellent low-

speed sensitivity give extremely accurate trip distances–but only if the unit

is calibrated precisely with an accurately measured tire circumference. See

setup instructions for the method for accurately measuring circumference.

Use the Cyclometer 45tt's Trip Distance function to follow a route slip or

to create a route slip for a tour with exact distances to turns and land-

marks. In racing, Trip Distance will tell you how far you are into the

course.

TOTAL DISTANCE (D).

After accumulating 19,999 miles the display freezes. Reset or adjust in

Total Distance Setup. To record yearly mileage, reset before your first ride

of a new year.

If you have accumulated over 12,500 miles total distance, then change

your Cyclometer to display kilometers, you will exceed the display capac-

ity of 19,999. However this distance will be retained and will be displayed

again upon returning to miles.

Trip distances up to 199.99 miles are displayed

Whole miles up to 19,999 are displayed.

DESTINATION DISTANCE/TIME.

Trip/Total Distance function to reach Destination Distance. Destination

distances of up to 199.99 miles can be entered into the Cyclometer 45tt

and will begin to count down when the function is turned on by pressing

the left button. When the function is turned on, the "D" and the colons in

the time display flash. After distance reaches zero, negative distance accu-

mulates to -9.99 mi. At -9.99 the function resets to zero and turns off. The

upper display shows the time during which the destination distance has

been counting down.

ENTERING DESTINATION DISTANCE.

distance function hold down the left button until the lower right digit

flashes (3 seconds). Enter hundredths of a mile by pressing the left button.

Press the right button to go to tenths of a mile, whole miles, and tens of

miles. You can also enter 100 miles, but note that no number flashes until

you press the left button to enter 1 in the hundreds position. If you don't

enter a 1 in the hundreds position, you must press the right button twice to

complete your entry. When the entry is complete the lower screen flashes

once to confirm.

USING DESTINATION DISTANCE.

enter the course distance in advance, then activate the function at the start

line. Timing does not begin until the wheel turns. The relationship be-

tween remaining distance and elapsed time is constantly displayed so you

can apportion your effort. At the finish, lock in the time and distance by

pressing the left button. On any touring or training ride you can enter the

distance to a town, landmark, or ride's end from a map, road sign, or from

data collected by your Cyclometer.

Press the left button in the

In the destination

In a time trial, you can