Fender "Custom" Vibtasonic Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Amplificador para instrumentos musicales Fender "Custom" Vibtasonic. Fender "Custom" Vibtasonic 7 páginas.

Imprimir página

"CUSTOM" VIBRASONIC REAR PANEL FUNCTIONS

FUSE - The fuse is in the AC supply of the amplifier

and will help to protect the amplifier and operator in

the event of an electrical fault. If a fuse blows, it

should only be replaced with a fuse in accordance

with the listing at the fuse holder. If the amplifier

repeatedly blows fuses, it should be checked out by a

qualified technician. UNDER NO CIRCUMSTANCES

should a fuse of a different type, higher current rating,

or a fuse bypass be used, as this could damage the

equipment and present a serious safety hazard.

POWER SWITCH - This switch turns the AC power ON

and OFF. When the switch is OFF, the amplifier is

completely shut down.

STANDBY SWITCH - This switch turns the amplifier on

and off. In the STANDBY position, the amplifier is off;

however, power is applied to the tube filaments so as

to eliminate warm-up time. Use of this feature during

short breaks versus using the POWER SWITCH will

increase tube life.

MAIN SPEAKER JACK - Plug-in connection for speak-

ers. This jack must always be used as the primary

connection to speakers.

EXTERNAL SPEAKER JACK - Plug-in connection for an

external speaker. This jack is wired in parallel with the

MAIN SPEAKER JACK, and must only be used in con-

junction with the MAIN SPEAKER JACK. Should the

EXTERNAL SPEAKER JACK be used without also using

the MAIN SPEAKER JACK, there will be no sound.

Note that the amplifier is optimized for a 4 ohm

speaker load, and that the 15" speaker in the cabinet

is 4 ohms. Should a total load of more or less than 4

ohms be used, the amplifier will not put out its maxi-

mum power output before distortion occurs.

FOOTSWITCH JACK - Plug-in connection for the

footswitch. The footswitch allows you to turn the

VIBRATO and REVERB features on and off without

having to operate the controls on the front panel.

Note that only the REVERB feature will operate without

plugging in the footswitch.