AVOCOR AVF-7550 Manual de inicio rápido - Página 15

Navegue en línea o descargue pdf Manual de inicio rápido para Monitor AVOCOR AVF-7550. AVOCOR AVF-7550 20 páginas.

Installing an OPS Module

Follow the steps below to install an OPS module.

Step 1. Ensure that the display is turned off

Step 2. Use a screw driver to unscrew the OPS slot shield on the display input panel. Do not

lose the screws that are removed.

Step 3. Install the OPS module by sliding it into the OPS slot until you hear a click, indicating

the module is securely inserted. When using an Avocor OPS PC, the fan should be visible

Step 4. Secure the OPS module in position by screwing it onto the display input panel using

the screws that were removed earlier.

Step 5. Ensure the installation is complete before turning on the power.

Step 6. Turn on the display. When using an Avocor OPS Pc you should see a green light on

the side of the OPS, this will indicate that the OPS PC is switched on and operational.

Note. When installing or de-installing an OPS PC, the display must be switched off. If the display is on when

performing the installation or deinstallation of the OPS PC, this could cause damage to either the display or OPS PC

invalidating the warranty for both.

Step 2

Step 4

v.30_05_2018

Step 3

Step 5