CP Electronics EBDSPIR-HB-AD Manual del producto - Página 6

Navegue en línea o descargue pdf Manual del producto para Sensores de seguridad CP Electronics EBDSPIR-HB-AD. CP Electronics EBDSPIR-HB-AD 12 páginas. High bay analogue dimming pir presence detector

Imprimir página

4. Programming

All the following functions can be programmed using the remote control DD-LCDHS-LR handset:

Detector Parameters (factory default in brackets):

1.1 Time adjustment

1.2 Sensitivity On (9)

1.3 Sensitivity Off (9)

1.4 Power Up On (Y)

1.5 Walk Test (N)

1.6 Disable Detector (N)

1.7 Factory Default

Modes (factory default in brackets):

2.1 Channel Modes

2.1.1 Switch only

2.1.2 Switch and dim together (default)

2.1.3 Switch and dim separate

2.2 Switch Modes

2.2.2 2 position switch separate

2.2.3 1 position switch together

2.2.4 1 position switch separate

Switching Channel 1 functions (factory default in brackets):

3.1 Presence detection

3.2 Absence detection

3.3 Switch level on (9)

3.4 Switch level off (9)

page 6

10 seconds to 99 minutes time delay (select 0 for 10 second

delay – use for commissioning only).

Sensitivity level when the detector is already operational

adjustable between 1 (min.) and 9 (max.)

Sensitivity level for switching the detector on – adjustable

between 1 (min.) and 9 (max.).

Select No for a 30 second delay on start up. If Yes is selected,

there will be no delay on start up and the detector will always

power up detecting.

An LED behind the detector lens will flash to show movement

has been detected (use for commissioning).

Disables detection, leaving the relay output permanently off

with the dimming output operational. This mode is used when

the unit is for maintained illuminance only.

Restores factory default settings.

Usually used for absence detection - in this mode the dimming

channel is not used.

The detector will switch and dim the lighting together.

Not used

A single centre biased retractive switch will be used to

control dimming and switching.

A single centre biased retractive switch will be used to

control dimming and switching.

Not used.

Auto switch on with detection, auto off after movement ceases

and time delay ends.

Manual switch on, auto off after movement ceases and time

delay ends.

Lux level setting to prevent the luminaires being switched on if

the ambient light level is sufficient (adjustable between 1

and 9). The luminaires will always be switched on at level 9.

For a higher resolution of ‗switch level on' a scale of 101-199

is available in the ‗Special menu'.

Lux level setting to switch the luminaires off during occupancy

if the ambient light level goes above the setting (adjustable

between 1 and 9). Level 9 will always keep the lights on. This

setting can be used for ―window row switching‖.

For a higher resolution of ‗switch level off' a scale of 101-199

is available in the ‗Special menu'.