Billi 926060 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Productos de fontanería Billi 926060. Billi 926060 9 páginas. Dispenser options: xl and mixer tap, al
También para Billi 926060: Manual de instalación (7 páginas)

Imprimir página

Warnings and Important Information cont.

Boiling water is dangerous and can cause severe burns, particularly with young children. Boiling water must always be handled with caution.

Use this appliance only as directed in these instructions and only for the purpose for which it has been designed.

Your Billi OmniOne is designed to be safe and practical. In an environment with young children, it is recommended that the boiling water

safety switch is activated.

In addition, the following safety features have also been included:

- Ergonomic levers.

- Levers/touch activations located safely away from water outlets.

- Dispenser remains cool to touch during regular use.

- Childproof safety switch.

- User settable maximum boiling water temperatures.

General Maintenance

Your Billi OmniOne has been designed to require minimal maintenance other than replacement of filter cartridges.

During each filter change, check all water connection and fittings for signs of leakage, all tubing for any signs of damage and in the cupboard

area around the base of unit for any signs of moisture.

There are no user serviceable components inside the appliance aside from the user replaceable filter cartridge. The appliance is only to be

opened by a suitably qualified person such as a representative from the manufacturer.

Dispenser Care

Proper care of Billi electronic dispensers is crucial to prevent premature wear of surface finishes and to ensure reliable dispense operation.

Avoid using abrasive cleaners on any external surfaces of the dispenser. Wipe clean only using a damp cloth. Use of a non-solvent, non-

smearing cleaner such as Windex is recommended. DO NOT pour water directly over the dispenser.

Cupboard Ventilation Requirements

Your Billi OmniOne appliance requires no cupboard ventilation, however a small air gap of 10mm around each side of the appliance is

recommended.

Care should be taken when installing the appliance and when using the cupboard space to avoid stretching or damaging pipework and power

cords associated with the appliance. Always ensure that access to the power point and the inlet water supply tap is not restricted.

Technical support

Warranty registration

R290 REFRIGERANT WARNINGS

WARNING:

RISK OF FIRE/FLAMMABLE MATERIALS

NOTE: This appliance uses 0.055 kilograms of R290 flammable refrigerant in a sealed system. The following must be observed for

your safety.

- This appliance contains a small quantity of R290 refrigerant, which is environmentally friendly but flammable. It does not damage the

ozone layer, nor does it contribute to the greenhouse effect.

- During transportation and installation, ensure that the tubing of the refrigerant circuit is not trapped or damaged.

- Leaking refrigerant can ignite or cause irritation and permanent damage to the eyes or respiratory system.

- In the event of any damage or if a leak does occur:

• Immediately isolate and disconnect the appliance from mains power.

• Avoid exposure to open flame or any device which could cause ignition via a spark or similar.

- Vacate and thoroughly ventilate the room in which the appliance is located for several minutes.

- Contact and notify Customer Support for necessary actions and advice.

- The room in which the appliance is installed must have a size of at least 1 cubic metre per 0.08 kilograms of R290 refrigerant. The

refrigerant quantity contained in this appliance is listed above in kilograms and also listed on the rating plate affixed to the appliance.

- Keep ventilation openings in the appliance enclosure or built-in structure clear of obstruction.

- It is hazardous for anyone other than an authorised service person to carry out servicing or repairs to this appliance. In some

jurisdictions the authorised person must hold a Gas Work Authorisation for hydrocarbon refrigerant before carrying out works that

involve the removal of covers.

WARNING

The environment and personal safety must be considered when disposing of this appliance. Please ensure the appliance is taken to a recycle

centre for safe recycling. DO NOT dispose of this appliance in landfill as the refrigerant gas contained in this appliance is flammable.

DISPOSAL

Superseded equipment holds residual recovery value and forms part of Billi's Global Greentag certified cradle to cradle philosophy.

An environmentally friendly method of disposal will ensure that valuable raw materials can be recovered and used again.

The refrigerant used in your appliance requires special disposal procedures. Up to date information for disposing of your old appliance and

packaging from the new one can be obtained from your local council office.