Allied Telesis AR400 Series Cómo configurar

Navegue en línea o descargue pdf Cómo configurar para Interruptor Allied Telesis AR400 Series. Allied Telesis AR400 Series 6 páginas. How to set up pppoe between a linux client and access concentrator
También para Allied Telesis AR400 Series: Manual de solución de problemas (8 páginas), Solución de problemas (5 páginas), Manual de instalación rápida (8 páginas), Manual de instalación rápida (12 páginas), Manual de información de seguridad (18 páginas), Cómo hacerlo (8 páginas)

AlliedWare™ OS

Configure Dynamic Routing Over An L2TP Tunnel

How To |

Introduction

This How To Note shows an example of using a dynamic routing protocol over an L2TP

tunnel.

Running dynamic routing protocols over a secure Internet connection can be a complex

issue, with the possibility of intermittent connections causing routing problems.

OSPF (or BGP) are more connection-oriented than RIP and therefore are more susceptible

to problems caused by intermittent loss of connection between 'neighbours'. A neighbour

that may bounce up and down can cause havoc to the correct propagation of OSPF routing

information for a network.

The following example scenario is for setting up RIP over an L2TP tunnel. RIP is simpler and

has less overhead and control, so it provides a more robust setup as a dynamic routing

protocol over an L2TP tunnel.

Which products does it apply to?

This Note applies to the following Allied Telesis routers, running software version 2.6.1 or

later:

AR400 series

AR700 series

C613-16037-00 REV C