Aqua PRO ECO500 Manual de inicio rápido - Página 11
Navegue en línea o descargue pdf Manual de inicio rápido para Calentador de piscina Aqua PRO ECO500. Aqua PRO ECO500 12 páginas. 50,000 btu heat & cool heat pump pool and spa heater
Imprimir páginaC In order to protect the swimming pool heater, the machine is equipped with a time lag starting
function, when starting the heat pump, the blower will run 3 minutes earlier than the compressor.
D After the swimming pool heater starts up, check for any abnormal noise from the machine.
Precautions
Attention
A Set proper temperature in order to get comfortable water temperature; to avoid overheating or
overcooling.
B Please don't stack substances that can block air flow near inlet or outlet area, or the efficiency of
the heater will be reduced or even stopped.
C Please don't put hands into outlet of the swimming pool heater, and don't remove the screen of
the fan at any time.
D If there are abnormal conditions such as noise, smell, smoke and electrical leakage, please
switch off the machine immediately and contact the local dealer. Don't try to repair it yourself.
E Don't use or stock combustible gas or liquid such as thinners, paint and fuel to avoid fire.
F In order to optimize the heating effect; please install heat preservation insulation on pipes
between swimming pool and the heater. During running period of the swimming pool heater, please
use a recommended cover on the swimming pool.
G Connecting pipes of the swimming pool and the heater should be ≤10m, or the heating effect of
the heater cannot be ensured.
Safety
A Please keep the main power supply switch far away from the children.
B When a power cut happens during running, and later the power is restored; the heater will start
up automatically. So please switch off the power supply when there is a power cut, and reset temp
when power is restored.
C Please switch off the main power supply in lightning and storm weather to prevent from machine
damage that caused by lightning.
D If the machine is stopped for a long time please cut off the power supply and drain water clear of
the machine by opening the tap of inlet pipe.
Maintenance
A "Cut off" power supply of the heater before any examination and repair.
B In winter seasons, please drain water clear of the machine, "cut off" power supply to prevent any
machine damage, and cover the machine body with plastic foil to avoid dust.
C Please clean this machine with household detergents or clean water, NEVER gasoline, thinners
or any similar fuel.
11