AVPro Edge AC-MXNET-10G-SW48Q Manual de inicio rápido - Página 2
Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red AVPro Edge AC-MXNET-10G-SW48Q. AVPro Edge AC-MXNET-10G-SW48Q 8 páginas. The mxnet 10g sdvoe ecosystem
1. Select the Transceiver Mode
The encoder and decoder (transmitter/receiver) are combined into one chassis with a simple toggle
switch to select application functionality. By default, the transceiver is set to decoder mode.
Flip the ENC/DEC SELECT toggle switch to set the transceiver to encoder or decoder mode.
(Front Panel)
AC-MXNET-10G-TCVR
To the right of the toggle switch is a blue LED that indicates the selected mode:
LED is on = Encoder mode
LED is off = Decoder mode
2. Select the Transceiver Port Type
10GbE copper and fiber ports on each transceiver allow flexibility to utilize the cabling that best fits
the specific installation.
For Category Cable Connections
Flip the SDVoE SELECT toggle switch to the 10G BASE-T setting, then flip the POE SELECT toggle
switch to the 10G setting.
(Rear Panel)
AC-MXNET-10G-TCVR
Connect the SDVoE 10G BASE-T port on the transceiver to a 10G Copper PoE port on the network
switch.
Connect the power supply to the network switch. By using this method, no additional cabling is
required to power the transceiver as it will be powered by the network switch via PoE (Power-over-
Ethernet).
Page 2 of 8
MXNET 10G SDVoE
®
Quick Start Guide