Aqua Quip QC Series Instrucciones de instalación y manual del usuario - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación y manual del usuario para Iluminación de piscinas Aqua Quip QC Series. Aqua Quip QC Series 4 páginas. Surface-mounted led retro-fit pool light
También para Aqua Quip QC Series: Instrucciones de instalación y manual del usuario (4 páginas)
Imprimir página
IMPORTANT INFORMATION FOR INSTALLER AND POOL OWNER
• Pool light must be fully submerged before switching on. If the light overheats due to operation out of water, the
inbuilt "run dry" thermal cut-out will engage and the LEDs will operate at a greatly reduced intensity until power
is shut down for 5 minutes and turned back on.
• Always allow sufficient cable length behind the pool light to enable future servicing.
• Only use stainless steel screws provided, using inferior quality screws voids the warranty.
• Internal components are not user-serviceable. Return to place of purchase for service.
• Never stare directly at LED lights, prolonged direct exposure can cause eye damage.
• Only use the stainless steel screws provided with the QC Series LED Pool Light, the use of incorrect screws
voids the warranty.
• Keep the protective Cable Cap for possible future use.
• Please make careful note of where the pool builder or electrician locates the transformer(s) and junction box(es).
This information is necessary if future servicing is required.
QC SERIES LIGHT PARTS DIAGRAM
1
B
QC SERIES LED LIGHT PARTS LIST
A
APL 802 Cable Hook
B
ASN 366 Cable Nut
C
ASN 367 Washer
D
ASN 374 Blue Seal
ASN 365 Cable Clamp
E
F
APL 806 Screw Kit for Cable Bracket
G
APL 804 Cable Bracket
H
ASN 363 Connector Housing
I
ASN 380 O-ring Kit
QC SERIES SURFACE MOUNTED LED LIGHTS FOR CONCRETE POOLS – INSTALLATION INSTRUCTIONS & OWNERS MANUAL
QC SERIES
Diagram 3
2
F G
C
D
H
E
I
J
ASN 611 Female Pin Kit
K
ASN 362 Female Plug
L
APL 803 Cable Cap
1
APL 050 Universal Mounting Bracket
LED 375 Quick Connect Plug Kit
2
3
Light Only –
4
LED 151 Design Ring
5
APL006 PE6 Screw Kit
6
APL071 Optional Retro-fit Screw Kit
Diagram 4 shows the Quick Connect Plug Kit at the end
of the cable now attached to the rear of the QC Series
LED Pool Light. Excess cable wraps around the three
hooks located on the rear of the pool light.
The Light is factory-sealed and assembled with a clear
lens with proprietary diffusion material, ensuring the vivid
colours of the LEDs (contained within) are projected and
evenly dispersed throughout the pool.
Diagram 4
SURFACE MOUNTED LED
LIGHTS for CONCRETE POOLS
3
A
J
K
L
see codes next column
4
LIGHT ONLY – CODES
3
LED 021 QC Blue Light
3
LED 022 QC White Light
3
LED 023 QC Green Light
3
LED 024 QC Multi-Colour Light
6
APL 071 Retro-
Fit Screw Kit for
wall mounting
(optional extra)
5
3