CPI Talos T8 Manual

Navegue en línea o descargue pdf Manual para Validador de billetes CPI Talos T8. CPI Talos T8 2 páginas.
También para CPI Talos T8: Manual de instalación (18 páginas)

Imprimir página
Talos T6/T8
Coupon Guide
TM
Carefully cut coupon from this page or make one copy of this coupon.
Copies are usable if made on a standard, carbon-based copier. Make one copy of the original at a
time, as copiers tend to reduce the size of the coupon when multiple copies are made.
Fill out the coupon using a #2 (HB) pencil. Fill in one block for each line. Do not mark the back of
the coupon.
Note that Talos units are preconfigured with the following options enabled:
– Bill Ways Accepted: Four Way
– T6 Bills Enabled: $1 - $20
– T8 Bills Enabled: $1 - $100
– Pulse Width: Gaming Short
– Pulses Per Dollar: One
– Interface Mode: Harness Enable
– Acceptance Mode: Mode Zero
Initiating Coupon Mode
1. Remove the bill magazine
2. Use a pencil or a screwdriver to press
this button to enter configuration mode,
then reattach the bill magazine to
initiate Coupon mode:
When coupon mode is activated, the bezel lights will rapidly flash
1. Insert a completed configuration coupon
2. Watch the bezel LEDs and count the flashes when the configuration coupon is returned
3. Use this chart to confirm successful programming:
Flashes
Meaning
10
Configuration coupon accepted and unit successfully programmed.
Coupon rejected. Number of flashes corresponds to the coupon section that was
1 - 5
improperly filled out. Try again.
7
Coupon not read. Confirm the coupon correct and try again.
253158027 G1