DG ZCU102 Manual de inicio rápido - Página 8
Navegue en línea o descargue pdf Manual de inicio rápido para Hardware informático DG ZCU102. DG ZCU102 15 páginas. Fpga setup for 2-ch raid0 by nvme-ip demo
Imprimir páginadg_nvmeip_raid0x2_fpgasetup_xilinx_en.doc
b) For Quad M.2 card, please follow below steps.
i. Insert two M.2 NVMe SSDs to M2_1 and M2_2 connectors on Hyper Quad M.2
card, as shown in Figure 2-2.
Figure 2-2 Two M.2 NVMe SSDs on Hyper Quad M.2 Card
ii. Confirm that two mini jumpers are inserted at J5 connector on AB18. After that,
connect FPGA Side (A-side) on AB18 to PCIe connector on FPGA board and
connect Hyper Quad M.2 NVMe SSD Card to device side (B-Side) on AB18, as
shown in Figure 2-3.
Warning: Please confirm that the Hyper Quad M.2 Card is inserted in the
correct side of AB18 (B-side, not A-side) before power on system.
iii. Connect ATX power supply to AB18-PCIeX16 board.
Figure 2-3 AB18, Quad M.2 Card, and FPGA board connection
3-Aug-22
Page 8