Allied Telesis SB244-03 Especificación - Página 8

Navegue en línea o descargue pdf Especificación para Interruptor Allied Telesis SB244-03. Allied Telesis SB244-03 8 páginas. Allied telesis series switches data specification

Imprimir página

PCR: 02415

Module: IPG

Packets with a RIP source address and next hop address that are not on the

same subnet as the interface will now be processed. If the received next hop

is not on the same subnet, it is treated as 0.0.0.0.

PCR: 02420

Module: SWI

On GBICs, the link was forced up when the transmit fibre was removed.

Once up, the link could not be taken down again by removing the transmit

fibre. This issue has been resolved.

PCR: 02423

Module: SWI

IGMP messages sometimes caused a fatal error. This issue has been

resolved.

PCR: 02425

Module: IPG

Multicast downstream groups are now added and deleted correctly.

Errata

AT-9800 Series Switches do not have Ethernet interfaces (for example, eth0).

Previously released documentation incorrectly states that these interface types

are valid. AT-9800 switch ports are Ethernet ports, and these are referenced in

commands with the PORT parameter.

IPSec and ISAKMP are not available on the 2.4.4 release for SwitchBlade 4000

Series Switches and AT-9800 Series Switches.

Availability

Patches can be downloaded from the Software Updates area of the Allied

Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html. A

licence or password is not required to use a patch.

Patch Release Note

Network affecting: No

Patch SB244-03 for Software Release 2.4.4

C613-10349-00 REV C