CPI Talos T8 Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Contadoras y clasificadoras de monedas CPI Talos T8. CPI Talos T8 18 páginas.
También para CPI Talos T8: Manual (2 páginas)

Imprimir página

This chapter outlines:

•

The compatible vending interface for the note validator

The interface refers to the transfer of electronic data to and from the note validator and the controlling device.

The controlling device in a vending machine is the Vending Machine Control (VMC).

The signals transferred to the note validator are control signals which may include:

The control system is ready to accept money.

The denomination of note to accept.

Whether or not notes should be returned from escrow.

Interface

Multi-Drop Bus (MDB)

Extended Bi-Directional Serial (EBDS)

Non-Isolated Serial (NISR)

Vending and gaming pulse interfaces

The following harnesses are available to support these interfaces:

Part Number

250077006C

250075007C

01-12-139C

250071043C

250070079C

250079049C

These harnesses fit onto the male connectors located on the left side of the note validator

connect to the machine controller's or coin changer's note validator interface harness.

For pinout information see

For further information on either interface harnesses or mounting kits, please contact your supplier or go to

Partners to find a CPI Authorized Service Center near you.

Description

Power cable (low level pulse, serial interface)

Power cable (gaming and EBDS interface)

Multi-Drop Bus interface (MDB)

Power cable (pulse interface)

RS232 cable

Section 9.

Power Specification

24 V

115/24/12 V

Power Specification

115 VAC

24 VAC

115 VAC

24 VAC

12 VDC

N/A

Published by CPI

Talos™ T6/T8 Note Validator

(See Figure

1) and are designed to

CPI Support

and select Service

01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN