CPI 1132 Series Manual de montaje - Página 15

Navegue en línea o descargue pdf Manual de montaje para Antena CPI 1132 Series. CPI 1132 Series 15 páginas.

CPI Satcom & Antenna Technologies

SECTION IV

4.0

After installation, the antenna requires only periodic inspection.

anticipated that maintenance, if required, will be minimal and easily handled

by a local or in-house maintenance staff.

4.1

CPI's reflector does not require any maintenance. The composite construction of

the reflector is virtually impervious to any damages that could be caused by

weather or atmospheric conditions. It is only necessary to inspect for any physical

damage done by vandalism or very severe weather conditions.

Should any damage be detected to a portion of the reflector, contact the Customer

Service Department at CPI for recommendations involving reflector repair.

4.2

MOUNT AND REFLECTOR SUPPORT STRUCTURE

The mount and reflector support structure supplied with this antenna is of steel

construction and has a galvanized finish.

If there are any signs of structural failure, the mount members that are damaged

should be repaired or replaced.

4.3

FEED AND FEED SUPPORT

The feed support and feed rods should be inspected to insure that all hardware is

secure. The feed/radio mounting bolts should be tight.

The feed horn window should be inspected to insure that it is intact so that no

moisture can collect inside the feed horn.

MAINTENANCE

1.2M Ku-BAND Rx/Tx SERIES 1132

4096-630

It is