CPI Alio Note Manual de instalación - Página 8

Navegue en línea o descargue pdf Manual de instalación para Lector de tarjetas CPI Alio Note. CPI Alio Note 12 páginas.

Imprimir página
Installation
3.4.1

Removing existing old telemeter and bezel from note validator

1
Turn off power to the vending machine.
2
Use the nut driver to
and remove note validator. Keep nuts for reassembly.
3
Disconnect the note validator's cabling.
4
Disconnect all connections to the telemeter.
5
Remove the antenna from the top of the vendor.
6
Seal the antenna hole in the machine (cp. your company's procedure).
The hole is no longer needed because the antenna is contained within the new card reader bezel.
7
Remove screw fixing the note validator's control board cover and pull to remove. Keep the screw
for reassembly.
: :
The Series 2000 control board cover is not attached with a screw. When installing onto a Series 2000, slide the cover off of the
chassis.
8
Disconnect the ribbon cable if the existing bezel is connected to the control
board.
9
Unscrew four bezel screws and remove the bezel and its mounting plate.
3.4.2

Installing the Alio Note card reader

10
Use two of four identical fixing screws enclosed in the hardware bag to fasten the card reader's mounting plate to the note validator.
11
Route card reader ribbon cable to the top and over the mounting plate.
12
Use the two remaining fixing screws to fasten the card reader at the top and a smaller fixing screw to fasten the card reader to the note
validator at the bottom.
13
Route the connection hub cable and the green ground cable through the cable management slot in the mounting plate.
14
Attach the card reader's ribbon cable to the note validator's control board.
8
unscrew the four hex nuts from the note validator's mounting posts
Please make sure that the card reader's green ground cable is not pinched when fastening the card reader
in the next step.
Older note validators might not provide a suitable ribbon cable connector. In this case, do not remove the
ribbon cable. Just route it up as shown in Fig. 6 and leave it in routed position.
Published by CPI
Alio™ Note Card Reader
7
Fig. 4: Removing note validator's control board cover
9
Fig. 5: Removing note validator bezel and mounting plate
44060-IG-01-01-EN_CPI_Alio Note Card Reader_Installation Guide_V1.0_.docx