AVstumpfl vario SHIFT-LEG ADAPTION Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para proyectores AVstumpfl vario SHIFT-LEG ADAPTION. AVstumpfl vario SHIFT-LEG ADAPTION 13 páginas.
Imprimir páginaDISASSEMBLY
For disassembly the same safety instructions apply as for assembly and set up. Bring down a
projection screen with the appropriate number of people to avoid falling over of the screen.
Falling parts can cause severe injury or death!
OPERATION, MAINTENANCE and SERVICE
FRAME ELEMENTS, LEGS and ACCESSORIES:
The frame elements, legs and additional elements are maintenance-free.
PROJECTION SURFACE:
The projection surface is packed into a separate lined soft bag to avoid any damage by the frame parts,
bleaching and discoloration.
Additionally, following instructions have to be adhered to:
Do not allow the projection surface to get in contact with sharp objects.
Do not bring printed and coloring objects (instructions, magazines, etc.) in contact with the
projection surface!
Do not write on the projection surface!
Colors penetrate the projection surface and cannot be cleaned anymore!
Store the projection surface cleaned and dry at room temperature only!
The projection surface has to be folded with the front layer inside; in order to avoid soiling and
damage.
When folding the projection surface insert the enclosed foamed plastic foil between snap buttons and
surface to avoid permanent marks.
COLD BREAK
A projection foil must never be stored or transported below 5° C. There is a risk of a cold break! The
film becomes very brittle and splinters like glass! When transporting the projection surface at low
temperatures do not unfold the surface unless it has reached its full elasticity at room temperature.
Otherwise there is the risk of cold break of the projection screen.
The ideal temperature range for assembling folding screens to prevent damaging the surface is 54°-
82° F (12°-28° C). Assembling below recommended temperatures may damage surface and void
warranty
CLEANING OF THE PROJECTION SURFACE
Use a white clean cotton cloth saturated with clear water (optionally mild soap water) and gently
wipe the area in one direction (no circular motion). Wipe dry with another cotton cloth.
To clean a stubborn stain, use methylated spirit and follow the same procedure.
Clean rear projection surfaces in case of imperative only!
6