Avtec TAKU Premier Ventilation Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Campana de ventilación Avtec TAKU Premier Ventilation. Avtec TAKU Premier Ventilation 12 páginas. Premier ventilation

Imprimir página

INSTALLATION REQUIREMENTS

FOR ALL AVTEC TAKU

VENTILATION HOODS

Figure 1

Figure 2

HANGER BRACKET DETAIL

HOOD

ANGLE

NOTE: HOLES DRILLED THROUGH HOOD ANGLE BY

INSTALLER AFTER BRACKET ATTACHMENT

POINTS HAVE BEEN DETERMINED.

Avtec hoods are provided with adjustable hanging brackets designed to receive 1/2"

threaded rod with a 1/2" nut and washer. Supporting rods must be connected to all factory

installed brackets. Recommended hanging height is 6'-6" above finished

canopies. Low side wall ventilators should be installed directly upon a Avtec base or on a

rerated wall. If wall mounted, the bottom of the vent should be 36" above finished floor.

ALL AVTEC VENTILATION SYSTEMS MUST BE INSTALLED IN ACCOR-

DANCE WITH NFPA-96, REMOVAL OF SMOKE AND GREASE-LADEN

VAPORS FROM COMMERCIAL COOKING EQUIPMENT.

CANOPIES

1. Check all local codes prior to installation. Special requirements may be necessary

depending upon building material construction.

2. Move crated hood to location of installation and very carefully uncrate hood.

3. Raise hood to proper hanging height.

4. Suspend hood from adequate roof supports using 1/2

and washers (See Fig. 1).

5. Level hood left to right and front to back.

6. Brackets are provided for hoods which are to be installed end to end or back to back.

Bolt brackets together using 3/8

7. Install C channel where the ends of the hood meet and install T moldings on front

face of hoods where they join. High temperature silicone can be used to install

channel and T moldings (See Fig. 3).

8. For make-up air hoods, the supply collar with built-in UL listed re damper and

air volume damper must be installed per instructions on collar.

9. Provide a removable service door in supply duct near re damper (See Fig. 4).

Figure 3

S.S. NUT & BOLT

BY OTHERS

HANGER ROD

NUT

PRE-DRILLED

HOLE, ACCEPTS

UP TO 1/2"ÿ ROD

PRE-DRILLED

HOLE, ACCEPTS

5/16" BOLT

OF HOOD

Installation Instructions

bolt through holes provided (See Fig. 2).

HOOD FACE

T-MOLDING

C-CHANNEL

threaded rods with nuts

Figure 4

INSULATED

SUPPLY DUCT

ACCESS

PANEL

FIRE DAMPER &

VOLUME CONTROL

DAMPER

floor for

EXHAUST DUCT

FLUID WELD