Allied Telesis Rapier Series Nota de publicación - Página 4

Navegue en línea o descargue pdf Nota de publicación para Enrutador de red Allied Telesis Rapier Series. Allied Telesis Rapier Series 8 páginas. How to set up pppoe between a linux client and access concentrator
También para Allied Telesis Rapier Series: Manual de solución de problemas (8 páginas), Solución de problemas (5 páginas), Cómo configurar (9 páginas), Cómo hacerlo (8 páginas)

Allied Telesis Rapier Series Nota de publicación
4
PCR: 03741
Module: FIREWALL
The maximum number of firewall sessions had decreased since software
release 86s-241. This issue has been resolved.
PCR: 03742
Module: IPV6
Previously, an incorrect source address was used for router advertisements
that were sent over an IPv6 tunnel. The source address of the tunnel
(specified by the IPADDRESS parameter of the ADD IPV6 TUNNEL
command) was used instead of a link local address. This caused an
interoperability problem, which has been resolved. Now, if the specified IP
address is not a link local address, then a link local address will be created
based on the IPv4 tunnel source address and used for router
advertisements.
PCR: 03743
Module: IP
If a ping was active and the IP configuration was reset, subsequent pings
were sent out the wrong interface. This issue has been resolved.
PCR: 03744
Module: PING
Executing a ping to the IP address 0.0.0.0 did not return an
destination address
was executed for local addresses, it timed out after 90 seconds. These issues
have been resolved.
PCR: 03764
Module: IPG
The IP multicast counter did not increment when IGMP, DVMRP and PIM
packets were transmitted and received. This issue has been resolved.
PCR: 03766
Module: FIREWALL
The firewall denied streaming data using Windows Media Player 9. This
issue has been resolved.
PCR: 03779
Module: DHCP
The DHCP client was not honouring a subnet option provided by the DHCP
server. This issue has been resolved.
PCR: 03783
Module: IPG
The TIMEOUT and SIZE parameters are only valid for the SET IP DNS
CACHE command, but no error message was returned if either parameter
was specified for the SET IP DNS command. This issue has been resolved.
PCR: 03784
Module: IPV6
Fragmentation of IPv6 packets now complies with RFC 2460's requirement
to align packet sizes to 8 octets.
PCR: 03788
Module: DHCP
The DHCP server did not send a DHCPNAK message when a previously
statically assigned IP DHCP entry was again requested by a client. This
issue has been resolved.
error message. Also, when the TRACE command
Patch Release Note
Level: 3
Level: 2
Level: 3
Level: 3
invalid
Level: 3
Level: 2
Level: 2
Level: 3
Level: 3
Level: 2
Patch 86253-03 for Software Release 2.5.3
C613-10382-00 REV B