Dell Inspiron 14 Intel Manual de servicio - Página 15
Navegue en línea o descargue pdf Manual de servicio para Portátil Dell Inspiron 14 Intel. Dell Inspiron 14 Intel 48 páginas. Service manual
Back to Contents Page
Thermal Cooling Assembly
Dell™ Inspiron™ N4020/N4030 Service Manual
Removing the Thermal Cooling Assembly
Replacing the Thermal Cooling Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
If you remove the thermal cooling assembly from the computer when the heat sink is hot, do not touch the metal housing of the
thermal cooling assembly.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Thermal Cooling Assembly
1. Follow the instructions in
Before You
2. Follow the instructions from
3. Disconnect the fan cable from the connector on the system board.
4. In sequential order (indicated on the thermal cooling assembly), loosen the four captive screws that secure the assembly to the system board.
5. Lift the thermal cooling assembly off the system board.
1 thermal cooling assembly
2 fan cable connector
3 captive screws (4)
Replacing the Thermal Cooling Assembly
NOTE:
This procedure assumes that you have already removed the thermal cooling assembly and are ready to replace it.
1. Follow the instructions in
Before You
2. Place the thermal cooling assembly on the system board.
3. Align the four captive screws on the thermal cooling assembly with the screw holes on the system board and tighten the screws in sequential order
(indicated on the thermal cooling assembly).
4. Connect the fan cable to the connector on the system board.
5. Follow the instructions from
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Begin.
step 2
to
step 14
in
Removing the System
Begin.
step 5
to
step 18
in
Replacing the System
Removing the
Board.
Board.
Battery) before working inside the