Dell Studio 1435 Manual de servicio - Página 24
Navegue en línea o descargue pdf Manual de servicio para Portátil Dell Studio 1435. Dell Studio 1435 42 páginas. Notebook dell studio 1435
Imprimir páginaBack to Contents Page
Hard Drive
Dell Studio™ 1435 Service Manual
Removing the Hard Drive
Replacing the Hard Drive
CAUTION:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE:
To prevent data loss, turn off your computer (see
while the computer is on or in Sleep state.
NOTICE:
Hard drives are extremely fragile. Exercise care when handling the hard drive.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not
covered by your warranty.
NOTICE:
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking tabs; if
you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly
aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive (see the Dell Technology Guide).
Removing the Hard Drive
1. Follow the procedures in
Before You
2. Turn the computer over and remove the base cover (see
3. Remove the two screws on the hard drive assembly.
1
screw (2)
2
3
pull tab
4. Pull the pull tab to disconnect the hard drive assembly from the system board connector.
5. Pull the interposer to detach it from the hard drive.
Turning Off Your
Begin.
Removing the Base
hard drive assembly
Computer) before removing the hard drive. Do not remove the hard drive
Cover).