Dell XPS 13 9315 2-in-1 Manual de servicio - Página 33
Navegue en línea o descargue pdf Manual de servicio para Portátil Dell XPS 13 9315 2-in-1. Dell XPS 13 9315 2-in-1 37 páginas.
También para Dell XPS 13 9315 2-in-1: Configuración y especificaciones (27 páginas), Manual de conexión de la pantalla externa (11 páginas)
Imprimir página
Table 19. System-diagnostic lights (continued)
Blinking pattern
Amber
3
3
3
3
3
NOTE:
Blinking 3-3-3 LEDs on Lock LED (Caps-Lock or Nums-Lock), Power button LED (without Fingerprint reader), and
Diagnostic LED indicates failure to provide input during LCD panel test on Dell SupportAssist Pre-boot System Performance
Check diagnostics.
SupportAssist diagnostics
About this task
The SupportAssist diagnostics (previously known as ePSA diagnostics) performs a complete check of your hardware. The
SupportAssist diagnostics is embedded in the BIOS and is launched by it internally. The SupportAssist diagnostics provides a set
of options for particular devices or device groups. It allows you to:
● Run tests automatically or in an interactive mode.
● Repeat tests
● Display or save test results
● Run thorough tests to introduce additional test options and provide extra information about the failed device(s)
● View status messages that indicate if the tests are completed successfully
● View error messages that indicate if problems were encountered during the test
NOTE:
Some tests are meant for specific devices and require user interaction. Ensure that you are present in front of the
computer when the diagnostic tests are performed.
For more information, see
White
3
4
5
6
7
SupportAssist Pre-Boot System Performance
Problem description
BIOS Recovery image not
found
BIOS Recovery image found
but invalid
Power rail failure
Flash corruption detected by
SBIOS.
Timeout waiting on ME to
reply to HECI message.
Check.
Suggested resolution
●
Flash latest BIOS version
●
If problem persists,
replace the system board.
●
Flash latest BIOS version
●
If problem persists,
replace the system board.
Replace the system board.
●
Press power button for
over 25 seconds to do
RTC reset. If problem
persists, replace the
system board.
●
Disconnect all power
source (AC, battery, coin
cell) and drain flea power
by pressing and holding
down power button 3~5
seconds to ensure all
power are drained.
●
Run "BIOS recovery from
USB", and the instructions
are in the website
Dell
support.
●
If problem persists,
replace the system board.
Replace the system board.
Troubleshooting
33