Avtek TS 7 Easy Manual rápido - Página 3

Navegue en línea o descargue pdf Manual rápido para Monitor Avtek TS 7 Easy. Avtek TS 7 Easy 5 páginas. Interactive flat panel

Avtek TS 7

Easy

1. Connect the Display to the mains socket

Connect the Display to the mains socket that supplies 110-240 V AC, 50/60 Hz.

2. Insert the batteries into the remote

Remove the screw that secures the battery

compartment cover on the back side of the remote

control first. Remove the cover gently. Insert two size

AAA batteries. Observe the correct polarity (+/-) when

inserting batteries. Do not mix old and new batteries.

Replace only with same or equivalent type. Place the

cover back on. Then screw the cover back on again.

3. Turn On/Off the Display

If the Display has an On/Off switch, after connecting the Display to the mains set the main On/Off switch to the "1" position.

The Display will switch into standby mode. Press the Standby button on the remote or press the centre of the joystick in located

on the rear left side of the Display to switch it on from standby. Press the centre of the joystick in and hold it down for a few

seconds or press the Standby button on the remote to switch the Display into standby mode. To switch the Display off, set the

On/Off switch to the "2" position.

Front view

(*) The location of the On/Off button may differ depending on the model.

4. Connect other equipments to the Display

PLEASE ENSURE BOTH UNITS ARE SWITCHED OFF BEFORE CONNECTING.

Use the proper cable to connect two together. To select the desired input,

press the Source button on the remote control.

Each time it is pressed the on-screen menu confirms your selection.

EXAMPLE CONNECTIONS

Quick guide manual

Back view

HDMI connection

VGA connection

Standby

button

Joystick

Interactive flat panel

Remote

Source

button

Remote

RS232 connection

Ethernet connection