Allied Telesis AT-8600 Series Nota de publicación - Página 5
Navegue en línea o descargue pdf Nota de publicación para Software Allied Telesis AT-8600 Series. Allied Telesis AT-8600 Series 6 páginas. Virtual chassis stacking
También para Allied Telesis AT-8600 Series: Solución de problemas (5 páginas), Folleto (12 páginas), Cómo configurar (9 páginas), Folleto (8 páginas)
Imprimir página
Patch sr264-03 for AT-8600 series switches
Patch sr264-03 for Software Release 2.6.4
C613-10407-00 REV C
The Authentication Server
The authentication server verifies the supplicant's details, passed to it by the
authenticator. This implementation of 802.1x control requires that a port acting
as an authenticator must communicate with a RADIUS authentication server.
The RADIUS server must be capable of receiving and deciphering EAP in
RADIUS packets.
The authentication server must be connected to a port on the switch which does not have
port authentication enabled, or is set with CONTROL=AUTHORISED.
The supported supplicant encryption mechanisms for communication with the
RADIUS server are EAP-MD5 and EAP-OTP. With this enhancement the
encryption methods supported by authenticators are EAP-MD5, EAP-OTP,
EAP-TLS, EAP-TTLS, and EAP-PEAP.
Steps in the Authentication Process
Until authentication is successful, the supplicant can only access the
authenticator to perform authentication message exchanges, or access services
not controlled by the authenticator's controlled port.
Initial 802.1x control begins with an unauthenticated supplicant and an
authenticator. A port under 802.1x control acting as an authenticator is in an
unauthorised state until authentication is successful.
1.
Either the authenticator or the supplicant can initiate an authentication
message exchange. The authenticator initiates the authentication message
exchange by sending an EAPOL packet containing an encapsulated
EAP-Request/Identity packet. The supplicant initiates an authentication
message exchange by sending an EAPOL-Start packet, to which the
authenticator responds by sending an EAPOL packet containing an
encapsulated EAP-Request/Identity packet.
2.
The supplicant sends an EAPOL packet containing an encapsulated
EAP-Response/Identity packet to the authentication server via the
authenticator, confirming its identity.
3.
The authentication server selects an EAP authentication algorithm to verify
the supplicant's identity, and sends an EAP-Request packet to the
supplicant via the authenticator.
4.
The supplicant provides its authentication credentials to the authenticator
server via an EAP-Response packet.
5.
The authentication server either sends an EAP-Success packet or
EAP-Reject packet to the supplicant via the authenticator.
6.
Upon successful authorisation of the supplicant by the authenticator server,
a port under 802.1x control is in an authorised state, unless the MAC
associated with the port is either physically or administratively inoperable.
Also upon successful authorisation of the supplicant by the authenticator
server, the supplicant is allowed full access to services offered via the
controlled port. If piggybacking is enabled on the authorised authenticator
port, any other device connected will also be give full access.
5