Dell Dimension 2200 Manual - Página 11

Navegue en línea o descargue pdf Manual para Servidor Dell Dimension 2200. Dell Dimension 2200 50 páginas. Vga card installation instructions
También para Dell Dimension 2200: Manual de sustitución (9 páginas), Instrucciones de instalación (1 páginas)

Imprimir página
Dell Dimension 2200 Manual
7.  Rotate the insert toward you, and remove it from the front panel.
If you permanently remove a drive from the drive cage, replace the front-panel insert by inserting its two tabs into the slot in the front panel and rotating the
insert forward until it snaps into place.

Upper 3.5-Inch Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
 Remove the computer
cover.
5.
 Remove the front
panel.
6.
 Rotate the power supply
away from the system board.
7.  Remove the metal drive bay plate covering the bay.
Using a screwdriver, pop out the metal plate from the left or right side of the computer.
 
8.  Remove the extra rails from the front of the computer frame.
9.  Install the rail marked "L" on the left side of the drive and the rail marked "R" on the right side of the drive.
 
"Safety
Instructions."